SENSe Subsystem 10
N1911A/1912A P-Series Power Meters Programming Guide 433
Reset Condition
On reset, autoranging is enabled.
Query
[SENSe[1]]|SENSe2:POWer:AC:RANGe:AUTO?
The query enters a 1 or 0 into the output buffer indicating the status of
autoranging.
– 1 is returned when autoranging is enabled
– 0 is returned when autoranging is disabled
Query Example
Error Messages
– If this command is set to OFF when there is not an E-Series power sensor or
N8480 Series power sensor (excluding Option CFT) connected, the error –241,
“Hardware missing” occurs.
– If this command is set to ON when E9320 power sensor is in Normal and
Triggered modes, the error -221, “Setting conflicts” occurs.
POW:AC:RANG:AUTO? This command queries whether auto ranging
is on or off.
To Next Page
Loading...
