SENSe Subsystem 10
N1911A/1912A P-Series Power Meters Programming Guide 443
Example
Reset Condition
On reset, gate 1 is set to 100 µs and other gates to 0 s.
Query
SENSe[1]]|SENSe2:SWEep[1]|2|3|4:TIME?
The query returns the current length of the time-gated period.
Query Example
Error Messages
– If the command is used when a sensor other than a P-Series or E9320 power
sensor is connected, error –241, “Hardware missing” occurs
– If the command is used when an E9320 sensor is connected and set to
AVERage mode rather than NORMal mode, the error –221, “Settings Conflict”
occurs.
SENS2:SWE3:TIME 0.001 This command sets the length to 0.001
seconds.
SENS2:SWE2:TIME? This command queries the length of the
time-gated period for Channel B and gate 2.
To Next Page
Loading...
