SENSe Subsystem 10
N1911A/1912A P-Series Power Meters Programming Guide 451
Reset Condition
On reset, the delay is set to 0 seconds.
Query
SENSe[1]|SENSe2:TRACe:OFFSet:TIME?
The query returns the current delay between the delayed trigger point and the
start of the trace.
Query Example
Error Messages
– If the command is used when a sensor other than a P-Series or E9320 power
sensor is connected, error –241, “Hardware missing” occurs
– If the command is used when an E9320 sensor is connected and set to
AVERage mode rather than NORMal mode, the error –221, “Settings Conflict”
occurs.
SENS:TRAC:OFFS:TIME? This command queries the current delay
between the delayed trigger point and the
start of the trace for Channel A.
To Next Page
Loading...
