SENSe Subsystem 10
N1911A/1912A P-Series Power Meters Programming Guide 453
Reset Condition
On reset, the duration is set to 100 µs.
Query
SENSe[1]|SENSe2:TRACe:TIME?
The query returns the current duration of the trace.
Query Example
Error Messages
– If the command is used when a sensor other than a P-Series or E9320 power
sensor is connected, error –241, “Hardware missing” occurs
– If the command is used when an E9320 sensor is connected and set to
AVERage mode rather than NORMal mode, the error –221, “Settings Conflict”
occurs.
SENS2:TRAC:TIME? This command queries the current duration
of the trace.
To Next Page
Loading...
