Keysight N1911A

STATus Subsystem 11
N1911A/1912A P-Series Power Meters Programming Guide 467
Each of these can be used to examine any of the following eleven status registers:
STATus:DEVice (page 473)
STATus:OPERation (page 476)
STATus:OPERation:CALibrating[:SUMMary] (page 477)
STATus:OPERation:LLFail[:SUMMary] (page 478)
STATus:OPERation:MEASuring[:SUMMary] (page 479)
STATus:OPERation:SENSe[:SUMMary] (page 480)
STATus:OPERation:TRIGger[:SUMMary] (page 481)
STATus:OPERation:ULFail[:SUMMary] (page 482)
STATus:PRESet (page 483)
STATus:QUEStionable (page 485)
STATus:QUEStionable:CALibration[:SUMMary] (page 486)
STATus:QUEStionable:POWer[:SUMMary] (page 487)
Examples
– To use the :CONDition? command to examine the STATus:DEVice register:
STATus:DEVice:CONDition?
–To use the :NTRansition command to examine the
STATus:OPERation:SENSe[:SUMMary] register:
STATus:OPERation:SENSe[:SUMMary]:NTRansition
This chapter describes the status register set commands and the status registers
which they are used to examine.