Keysight N1911A

SYSTem Subsystem 12
N1911A/1912A P-Series Power Meters Programming Guide 533
TRAC[1]|2:STAT OFF Disable trace capture
TRAC[1]|2:UNIT dBm Trace units
TRIG[1]|2:DEL:AUTO ON Insert settling time delay
TRIG[:SEQ]:DEL 0 Delay between recognition of trigger
event and start of a measurement
TRIG[:SEQ]:HOLD 1 µs Trigger holdoff
TRIG[:SEQ]:HYST 0 dB Fall/rise below/above TRIG:LEV
TRIG[:SEQ]:LEV 0 dB Power level
TRIG[:SEQ]:LEV:AUTO ON Enable automatic setting of trigger level
TRIG[:SEQ]:SLOP POS Trigger event recognized on rising edge
TRIG[:SEQ[1]|2]:COUN 1 Trigger events for measurement cycle
TRIG[:SEQ[1]|2]:DEL:AUTO ON Enable settling time delay
TRIG[:SEQ[1]|2]:SOUR IMM Trigger source set up
UNIT:POW dBm Power units
UNIT:POW:RAT dB Ratio units
Command Setting Comments