16 UNIT Subsystem
732 N1911A/1912A P-Series Power Meters Programming Guide
Example
Reset Condition
On reset, the value is set to DB.
Query
UNIT[1]|2|3|4]:POWer:RATio?
The query returns the current setting of the ratio measurement units.
Query Example
UNIT1:POW:RAT DB This command sets the ratio measurement
units for the upper window/upper
measurement.
UNIT2:POW:RAT? This command queries which ratio
measurement units are being used on the
lower window/upper measurement.
To Next Page
Loading...
