2JZ/2JX/2JV/2H7-1
1-3-74
U147
Setting for MODE3
1. Select [Set Value].
2. Select the color to be set.
3. Change the setting value using +/- keys.
4. Press the start key. The setting is set.
5. Select [Set MODE].
Setting: [Upper Limit]
1. Change the setting value using the +/- keys.
2. Press the start key. The value is set.
Setting: [Sleeve Cleaning]
1. Change the setting value using the +/- keys.
2. Press the start key. The value is set.
Setting: [Set Drum Cleaning Mode]
Modify settings only if faulty images, such as smear, occurs in a high humid environment.
1. Select the mode to be set.
Initial setting: MODE1
2. Press the start key. The setting is set.
Setting: [Set Minimum Value]
1. Change the setting value using the +/- keys.
The initial setting value depends on the setting of [Set Drum Cleaning Mode].
2. Press the start key. The value is set.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
Maintenance
item No.
Description
Display Description Setting range Initial setting
Black The magnification ratio which is multiplied
in the toner applying quantity for black
0 to 5.0 1.0
Cyan The magnification ratio which is multiplied
in the toner applying quantity for cyan
0 to 5.0 1.0
Magenta The magnification ratio which is multiplied
in the toner applying quantity for magenta
0 to 5.0 1.0
Yellow The magnification ratio which is multiplied
in the toner applying quantity for yellow
0 to 5.0 1.0
Display Description Setting range Initial setting
Upper Limit Upper limit printing ratio of toner applying
quantity with each mode
0 to 10 (%) 5 (%)
Display Description Setting range Initial setting
Sleeve Clean Int Toner collection operational interval on
developing sleeve after the toner applying
operation (T7 control)
10 to 300 (s) 60 (s)
Display Description
MODE1 Constitutes a toner layer if the print coverage is less than 2%.
(excludes the maximum paper width A3/A4)
MODE2 Apply toner regardless of the current print coverage.
Display Description Setting range Initial setting
Minimum Value Toner layer width (mm) 0 to 30 (mm) MODE1: 10
MODE2: 20
To Next Page
Loading...
