2JZ/2JX/2JV/2H7-1
1-3-130
U486
Setting color/black and white operation mode
Description
When color and B/W documents are mixed, sets operation mode after a color document is detected.
Purpose
To ensure productivity when copying color and B/W documents in ACS mode, select MODE4.
However, selecting MODE4 will increase the maintenance count for cyan, magenta, and yellow color develop-
ing units.
Setting
1. Press the start key.
2. Select the MODE.
Initial setting: MODE1
3. Press the start key. The setting is set.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
U510
Setting the enterprise mode
Description
Sets whether or not the enterprise mode setting is enabled.
This maintenance mode is effective for only 120 V specifications.
Purpose
According to user request, changes the setting.
Setting
1. Press the start key.
2. Select [MODE1].
3. Select the item.
Initial setting: ON (Inch specifications)
OFF (Metric specifications)
4. Press the start key. The setting is set.
Completion
Turn the main power switch off.
Maintenance
item No.
Description
Display Description
MODE1 Line speed: Color and B/W line speed is switched according to each original
Controlling developing motor MCY: Color and B/W mode is switched according to
each original
MODE2 Line speed: Fixed at color line speed
Controlling developing motor MCY: Color and B/W mode is switched according to
each original
MODE3 Line speed: Fixed at color line speed on and after a color original
Controlling developing motor MCY: Fixed at color mode on and after a color original
MODE4 Line speed: Fixed at color line speed
Controlling developing motor MCY: Fixed at color mode
Display Description
ON Enterprise mode setting is enabled
OFF Enterprise mode setting is disabled
INSTALL Executing the install
To Next Page
Loading...
