Kyocera TASKalfa 400ci - Connectors YC10 - YC12

2JZ/2JX/2JV/2H7-1
2-3-12
YC10 B9 CAS2 WIDTH2 I 0/3.3 V DC PWSW2: On/Off
Connected
to the main
high voltage
PWB, MP
conveying
unit switch,
paper size
length
switch 1/2,
paper size
width switch
1/2, power
source fan
motor 1/2
and MP
paper con-
veying
clutch
B10 CAS2 WIDTH1 I 0/3.3 V DC PWSW2: On/Off
B11 SGND - - Ground
B12 CAS1 WIDTH3 I 0/3.3 V DC PWSW1: On/Off
B13 CAS1 WIDTH2 I 0/3.3 V DC PWSW1: On/Off
B14 CAS1 WIDTH1 I 0/3.3 V DC PWSW1: On/Off
B15 HVU_FAN_REM O 0/24 V DC PSFM1/2: On/Off
B16 +24V1 O 24 V DC 24 V DC power to PSFM1/2
B17 +24V1 O 24 V DC 24 V DC power to MPPCCL
B18 MPFFED CLT
REM
O 0/24 V DC MPPCCL: On/Off
B19 NC - - Not used
B20 NC - - Not used
YC11 1 SGND - - Ground
Connected
to the fuser
thermistor 1/
2/3
2 FSR NCTH2 I Analog FTH2 detection signal
3 FSR NCTH1 I Analog FTH2 detection signal
4 +3.3V1 O 3.3 V DC 3.3 V DC power to FTH1
5 FSR TH1 I Analog FTH1 detection signal
6 +3.3V1 O 3.3 V DC 3.3 V DC power to FTH3
7 FSR TH2 I Analog FTH3 detection signal
8 SGND - - Ground
9 FSR SET I 0/3.3 V DC Fuser unit set signal
YC12 A5 SIDE DLP FAN - - Not used
Connected
to the trans-
fer fan motor
1 and waste
toner motor
A6 +24V1 - - Not used
A7 SIDE BELT FAN O 0/24 V DC TRFM1: On/Off
A8 +24V1 O 24 V DC 24 V DC power to TRFM1
A9 WT MT RTN I Analog WTM return signal
A10 WT MT DR O 0/24 V DC WTM: On/Off
B1 SP FAN - - Not used
B2 +24V1 - - Not used
B3 SGND - - Not used
B4 CONTAIN1_SET - - Not used
B5 SGND - - Not used
B6 CONTAIN2_SET - - Not used
B7 SGND - - Not used
B8 CONTAIN3_SET - - Not used
B9 SGND - - Not used
B10 CONTAIN4_SET - - Not used
Connector Pin No. Signal I/O Voltage Description