2JZ/2JX/2JV/2H7
1-5-28
(5) Manual color registration adjustment
Follow the procedure below to replace the laser scanner unit.
Procedure
1. Press the system menu key.
2. Press [User Adjustment]. Press [Color Calibrat.] ([Colour Calibrat.]).
Press [On]. Color calibration begins.
3. Press [Color Regist.] ([Colour Regist.]). Press [Configuration].
Press [PrintChart (Details)]. A chart is printed.
4. Press [InputValue (Details)].
Read figures at MH-1 to 7/CH-1 to 7/YH-1 to 7 and MV-3/CV-3/YV-3 of the reference chart and
enter the figure marked at the scale which the BK fine line is in line with the M/C/Y fine lines,
using the cursor up/down keys.
5. Press [Completed.] after all values have been entered. Color registration begins.
Figure 1-5-46
6. Press [Print Chart (Details)] to print a refer-
ence chart.
7. Verify that each scale is within the range of 1
to A. If they are within the range, proceed to
step 8.
If scales are out of range, repeat steps 4
through 7.
Figure 1-5-47
8. Verify that scales of MV-1,2,4,5/CV-1,2,4,5/
YV-1,2,4,5 coincide within the range of 1 to
A.
If they are within the range, adjustment is
complete.
If they are out of range, proceed to step 9.
Figure 1-5-48
Reference chart
Example:
Enter B as scales
are coincided at B.
The scales must coincide
within 1 to A.
Reference chart
To Next Page
Loading...
