2JZ/2JX/2JV/2H7-1
1-3-31
U052
Setting the fuser motor control
Description
Enters the sensor data values described on the supplied sheet provided when the loop sensor is replaced and
performs correction processing for the fuser motor.
Purpose
To perform when replacing the loop sensor or paper conveying unit.
Method
1. Press the start key.
2. Select the item. The screen for executing each item is displayed.
*: 25/25, 30/30 ppm model only.
Method: [Set Loop Sensor]
1. Select [Scanning Board1].
2. Enter the sensor data value of supplied sheet DATA1 using the cur-
sor +/- keys.
3. Select [Scanning Board2].
4. Enter the sensor data value of supplied sheet DATA2 using the cur-
sor +/- keys.
5. Press the start key. The value is set.
Setting: [Loop Sensor Control]
1. Select the item.
2. Select ON or OFF.
3. Press the start key. The setting is set.
Setting: [Loop Sensor Valid]
1. Select ON or OFF.
Initial setting: OFF
2. Press the start key. The setting is set.
Completion
Press the stop key. The indication for selecting a maintenance item No. appears.
Maintenance
item No.
Description
Display Description
Set Loop Sensor Enter the data value for loop sensor
Loop Sensor Control Set the loop sensor detection control
Loop Sensor Valid* Set whether to enable or disable the loop sensor
1(e.g.)
How to read the sensor data value
2
3
4
5
6
7
8
9
0
364
Display Description Initial setting
Top 250mm Sensor detection ON/OFF setting at 250 mm from
the top of paper
OFF
Top 290mm Sensor detection ON/OFF setting at 290 mm from
the top of paper
ON
Top 330mm Sensor detection ON/OFF setting at 330 mm from
the top of paper
ON
Top 370mm Sensor detection ON/OFF setting at 370 mm from
the top of paper
ON
Display Description
ON Loop sensor is enabled
OFF Loop sensor is disabled
To Next Page
Loading...
