2JZ/2JX/2JV/2H7
1-3-93
U246
Setting the paper ejection device
Description
Provides various settings for the optional 3000-sheet document finisher, if furnished.
Purpose
Adjustment of registration stop timing in punch mode
Adjust if skewed paper conveying occurs or if the copy paper is Z-folded in punch mode.
Adjustment of paper stop timing in the punch mode
To adjust this item when the position of a punch hole is different from the specified one.
Adjustment of front/rear side registration home position of Inner tray
Provides optimization when paper jam occurs due to an inferior fitting of the Inner tray adjuster guides to
paper.
Adjusting of front and back/slanted stapling home position
Adjusts the stapling position in the staple mode if the position is not proper.
Provides adjustment of slanted stapling.
Adjustment of upper/lower side registration home position of center-folding unit
Provides optimization when paper jam occurs due to an inferior fitting of the centerfold adjuster guides to paper.
Adjustment of booklet stapling position
Adjusts the booklet stapling position in the stitching mode if the position is not proper.
Adjustment of center folding position
Adjusts the center folding position in the stitching mode if the position is not proper.
Method
1. Press the start key.
2. Select the item to set. The screen for setting each item is displayed.
Method: [3000 FINISHER]
1. Select the item to set. The screen for setting each item is displayed.
Setting: [PUNCH REG ADJ]
1. Change the setting value using the cursor up/down keys.
If skewed paper conveying occurs (sample 1), increase the preset value. If the copy paper is Z-folded
(sample 2), decrease the preset value.
Figure 1-3-16
2. Press the start key. The value is set.
Maintenance
item No.
Description
Display Description
3000 FINISHER Adjustment of 3000-sheet document finisher
BOOKLET FOLDER Adjustment of center-folding unit
Display Description
PUNCH REG ADJ Adjustment of registration stop timing in punch mode
PUNCH POSITION ADJ Adjustment of the paper stop timing in punch mode
WIDTH F HP ADJ Adjustment of front side registration home position
WIDTH R HP ADJ Adjustment of rear side registration home position
STAPLE HP ADJ Adjustment of front and back stapling home position
TURNED STAPLE HP ADJ Adjustment of slanted stapling home position
Description
Setting
range
Initial
setting
Change in
value per step
Adjustment of registration stop timing -20 to 20 0 1 ms
Sample 1 Sample 2
To Next Page
Loading...
