2JZ/2JX/2JV/2H7-1
1-3-148
(8) Adjustment/Maintenance
Copy Density Adjustment
1. Press [Next] of Copy Density Adjustment.
2. Press [Change] of Auto or of Manual.
3. Press [-3] - [+3] (Lighter-Darker) to adjust density.
4. Press [OK].
Send/Box Density Adjust
1. Press and [Next] of Send/Box Density Adjust..
2. Press [Change] of Auto or of Manual.
3. Press [-3] - [+3] (Lighter-Darker) to adjust density.
4. Press [OK].
Print Density
1. Press [Change] of Print Density.
2. Press [1] - [5] (Lighter-Darker) to adjust density.
3. Press [OK].
Drum Refresh
1. Press [Next] of Drum Refresh.
2. Press [Execute] to Drum Refresh.
3. After Drum Refresh is completed, press [OK] to
return to the Adjustment/Maintenance screen.
Correcting Fine Black Lines
1. Press [Change] of Correcting Black Line.
2. Press [Off], [On(Low)] or [On(High)].
3. Press [OK].
Display Brightness
1. Press [Change] of Display Brightness.
2. Press [1] - [4] (Darker- Lighter) to adjust brightness.
3. Press [OK].
Silent Mode
1. Press [Change] of Silent Mode.
2. Press [Off] or [On].
3. Press [OK].
Auto Color Correction
1. Press cursor down key and [Change] of Auto Color
Correction.
2. Press one of keys [1] to [5] (Color - B & W) to set
the detection level.
3. Press [OK].
Color Registration
Normal Registration
1. Press cursor down key and then [Next] of Color
Registration.
2. Press [Print] of Chart. A chart is printed.
On the chart, for each of M (magenta), C (cyan)
and Y (yellow), 3 chart types are printed on one
sheet: H-F (left), V (right), H-R (horizontal).
3. Find the location on each chart where 2 lines most
closely overlap each other. If this is the 0 position,
registration for that color is not required. For the
illustration, B is the appropriate value.
4. Press [Next] of Registration.
5. Press [Change] for the chart to be corrected.
6. Press [+] or [-] to enter the values read from the
chart and press [OK].
Press [+] to increase the value from 0 to 9. To
decrease, press [-].
By pressing [-], the value changes from 0 to alpha-
betic letters, going from A to I. To move in the
reverse direction, press [+].
You cannot use the numeric keys to enter these
values.
7. Repeat steps 5 and 6 to enter the registration val-
ues for each chart.
8. Press [Execute] after all values have been entered.
Color registration begins.
9. Press [OK] after color registration is complete.
To Next Page
Loading...
