Kyocera TASKalfa 400ci - Optional Finisher

2JZ/2JX/2JV/2H7
1-4-8
Optional
DP
78
DP cover open
JAM
The DP or DP top cover is opened during original
feeding.
---
When the power is turned on or original feeding
starts, the original feed switch (OFSW), the original
registration switch (ORSW) or DP timing switch 1/2
(DPTSW1/2) turning on.
---
79
An original jam in
the original eject
section
During single scanning or dual scanning, the original
eject switch (OESW) does not turn on within speci-
fied time of the DP timing switch 1 (DPTSW1) turn-
ing on.
1705 ms 1038 ms 1038 ms
During duplex switchback scanning, the original
eject switch (OESW) does not turn on within speci-
fied time since switchback ejection starts.
841 ms 512 ms 512 ms
During single scanning or dual scanning, the original
eject switch (OESW) does not turn off within speci-
fied time of the DP timing switch 1 (DPTSW1) turn-
ing off.
1705 ms 1038 ms 1038 ms
Optional
finisher
80
Jam between the
finisher and
machine
Paper ejection is not output from the machine to the
document finisher within specified time of the paper
entry sensor (PES) turning on.
15 s 15 s 15 s
The paper entry sensor (PES) turns on before the
eject signal is output from the machine.
---
81
Paper entry sen-
sor non arrival jam
(3000-sheet document finisher)
The paper entry sensor (PES) is not turned off even
if a specified time has elapsed after the machine
eject signal was received.
1613 ms 1152 ms 968 ms
(3000-sheet document finisher)
The paper entry sensor (PES) is not turned on even
if a specified time has elapsed after the machine
eject signal was received.
1613 ms 1152 ms 968 ms
(3000-sheet document finisher)
The paper entry sensor (PES) does not turn off
within specified time of its turning on.
3547 ms 2533 ms 2128 ms
(Document finisher)
The paper entry sensor (PES) is not turned on even
if a specified time has elapsed after the machine
eject signal was received.
674 ms 803 ms 1124 ms
82
Jam in stapler
(3000-sheet document finisher)
The home position is not detected within the speci-
fied time when driving the staple motor.
600 ms 600 ms 600 ms
(Document finisher)
The staple home position sensor (STSPS) is not
turned on within the specified time when driving the
staple motor (STM).
---
Section Jam code Conditions
Specified time
25/25 ppm
30/30 ppm
40/40 ppm
50/40 ppm
Color
50/40 ppm
B/W