2JZ/2JX/2JV/2H7
1-4-9
Optional
finisher
83
Eject sensor stay
jam
(3000-sheet document finisher)
Eject switch 1 (ESW1) is not turned off within speci-
fied time of its turning on.
1404 ms 1404 ms 1404 ms
(Document finisher)
In the straight mode, the eject paper sensor (EPS) is
not turned off within specified time of its turning on.
---
(Document finisher)
In the bundle discharge mode or the staple mode,
bundle discharge operation does not turn off within
specified time since the operation starts.
902 ms 902 ms 902 ms
84
Jam in eject sec-
tion of right sub
tray (3000-sheet
document finisher
only)
Eject switch 2 (ESW2) is not turned off even if a
specified time has elapsed after the machine eject
signal was received.
1853 ms 1324 ms 1112 ms
Eject switch 2 (ESW2) is not turned on even if a
specified time has elapsed after the machine eject
signal was received.
1853 ms 1324 ms 1112 ms
Eject switch 2 (ESW2) is not turned off within speci-
fied time of its turning on.
3547 ms 2533 ms 2128 ms
85
Jam in eject sec-
tion of left sub tray
(3000-sheet docu-
ment finisher only)
Eject switch 3 (ESW3) does not turn off within speci-
fied time of paper entry sensor (PES) turning on.
2187 ms 1562 ms 1312 ms
Eject switch 3 (ESW3) does not turn on within speci-
fied time of paper entry sensor (PES) turning on.
2187 ms 1562 ms 1312 ms
Eject switch 3 (ESW3) is not turned off within speci-
fied time of its turning on.
3547 ms 2533 ms 2128 ms
87
Jam in eject sec-
tion of inner tray 2
(3000-sheet docu-
ment finisher only)
Inner tray entry sensor 2 (ITPES2) does not turn on
within specified time of the paper entry sensor (PES)
turning on.
3447 ms 2462 ms 2068 ms
Inner tray entry sensor 2 (ITPES2) does not turn off
within specified time of the paper entry sensor (PES)
turning off.
1371 ms 1371 ms 1371 ms
88
Jam in eject sec-
tion of main tray
(3000-sheet docu-
ment finisher only)
Eject switch 1 (ESW1) is not turned on within speci-
fied time.
1324 ms 1324 ms 1324 ms
At the time of bundle up initial operation, paper con-
veying belt home position sensor 1 (PCBHPS1)
does not turn on.
---
At the time of bundle down initial operation, paper
conveying belt home position sensor 2 (PCBHPS2)
does not turn on.
---
At the time of side registration standby operation,
side registration home position sensor 1 (SRHPS1)
does not turn off within specified time.
500 ms 500 ms 500 ms
At the time of side registration standby operation,
side registration home position sensor 2 (SRHPS2)
does not turn off within specified time.
500 ms 500 ms 500 ms
Section Jam code Conditions
Specified time
25/25 ppm
30/30 ppm
40/40 ppm
50/40 ppm
Color
50/40 ppm
B/W
To Next Page
Loading...
