Kyocera TASKalfa 400ci - U107 Setting the Transfer Cleaning Voltage

2JZ/2JX/2JV/2H7-1
1-3-58
U107
Setting the transfer cleaning voltage
Description
Sets the cleaning control voltage for transfer belt unit.
Purpose
Change settings if an offset has occurred due to the failure of cleaning the transfer belt.
Method
1. Press the start key.
2. Select the item to be set.
Setting: [Belt Clean A(F)]
1. Change the value using the +/- or numeric keys.
*1: 40/40, 50/40 ppm model *2: 25/25, 30/30 ppm model
2. Press the start key. The value is set.
Setting: [Belt Clean A(H)]
1. Change the value using the +/- or numeric keys.
*1: 40/40, 50/40 ppm model *2: 25/25, 30/30 ppm model
2. Press the start key. The value is set.
Setting: [Belt Clean B]
1. Change the value using the +/- or numeric keys.
*1: 40/40, 50/40 ppm model *2: 25/25, 30/30 ppm model
2. Press the start key. The value is set.
Maintenance
item No.
Description
Display Description
Belt Clean A(F) Transfer belt cleaning voltage (printing)
Belt Clean A(H) Transfer belt cleaning voltage (using thick paper)
Belt Clean B Transfer belt cleaning voltage (paper interval)
Belt Clean A(BW) Transfer belt cleaning voltage in black/white mode
Display Description Setting range Initial setting
Width<160 Small sizes (under 160 mm wide) 0 to 255 83
*1
/70
*2
160<=Width<220 Medium sizes (160 to under 220 mm
wide)
0 to 255 83
*1
/70
*2
220<=Width Large sizes (more than 220 mm wide) 0 to 255 83
*1
/70
*2
Display Description Setting range Initial setting
Width<160 Small sizes (under 160 mm wide) 0 to 255 62
*1
/50
*2
160<=Width<220 Medium sizes (160 to under 220 mm
wide)
0 to 255 62
*1
/50
*2
220<=Width Large sizes (more than 220 mm wide) 0 to 255 62
*1
/50
*2
Display Description Setting range Initial setting
Belt Clean B(F) Transfer belt cleaning voltage 0 to 255 150
*1
/140
*2
Belt Clean B(H) Transfer belt cleaning voltage (using thick
paper)
0 to 255 120
*1
/105
*2
Belt Clean B(BW) Transfer belt cleaning voltage in black and
white mode
0 to 255 150