Kyocera TASKalfa 400ci - U072 Adjusting the DP Center Line

2JZ/2JX/2JV/2H7-1
1-3-43
U072
Adjusting the DP center line
Description
Adjusts the scanning start position for the DP original.
Purpose
Make the adjustment if there is a regular error between the centers of the original and the copy image when
the optional DP is used.
Adjustment
1. Press the start key.
2. Select the item to be adjusted.
40/40, 50/40 ppm model
25/25, 30/30 ppm model
*: Dual scan DP only.
3. Press the system menu key.
4. Place an original on the DP and press the start key to make a test copy.
5. Press the system menu key.
6. Change the setting value using the +/- or numeric keys.
For copy example 1, increase the value. For copy example 2, decrease the value.
Figure 1-3-15
7. Press the start key. The value is set.
Caution
If the CCD first side is adjusted, check the CCD second side and if adjustment is required, carry out the
adjustment.
Check the copy image after the adjustment. If the image is still incorrect, perform the following adjustments in
maintenance mode.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
Maintenance
item No.
Description
Display Description
Setting
range
Initial
setting
Change in
value per step
ADJUST DATA1 DP center line of CCD (first side) -35 to 60 0 0.085 mm
ADJUST DATA2 DP center line of CCD (second side) -35 to 60 0 0.085 mm
ADJUST DATA3* DP center line of CIS -39 to 39 0 0.085 mm
Display Description
Setting
range
Initial
setting
Change in
value per step
ADJUST DATA1 DP center line of CCD (first side) -40 to 40 0 0.085 mm
ADJUST DATA2 DP center line of CCD (second side) -40 to 40 0 0.085 mm
ADJUST DATA3* DP center line of CIS -39 to 39 0 0.085 mm
Original Copy
example 1
Copy
example 2
U072
U404
(P.1-3-108)