2JZ/2JX/2JV/2H7-1
1-3-154
FTP (Transmission) Setup
1. Press [Next] of Network and then [Change] of FTP
(Transmission).
2. Press [On] or [Off].
Press [+] or [-] to change the port number as
desired. You can enter a port number between 1
and 65535.
3. Press [OK].
SMB (Transmission) Setup
1. Press [Next] of Network and then [Change] of SMB
(Transmission).
2. Press [On] or [Off].
Press [+] or [-] to change the port number as
desired. You can enter a port number between 1
and 65535.
3. Press [OK].
IPP Setup
1. Press [Next] of Network, cursor down key (twice)
and then [Change] of IPP.
2. Press [On] or [Off].
Press [+] or [-] to change the port number as
desired. You can enter any port number between 1
and 65535.
3. Press [OK].
4. After changing the setting, restart the system or
turn the machine OFF and then ON again.
Network Security
SSL Setting
1. Press [Next] of Network Security, and then [Next] of
SSL Setting.
2. Press [Change] of SSL.
3. Press [On].
4. Press [OK].
To set IPP port
1. Press [Change] of IPP Port Setting.
2. Press [IPP over SSL Only] or [IPP or IPP over
SSL].
3. Press [OK].
To set HTTP port
1. Press [Change] of HTTP Port Setting.
2. Press [HTTP or HTTPS] or [HTTPS Only].
3. Press [OK].
5. After changing the setting, restart the system or
turn the machine OFF and then ON again.
SNMPv3 Setting
1. Press [Next] of Network Security and then [Change]
of SNMPv3.
2. Press [On].
3. Press [OK].
4. After changing the setting, restart the system or
turn the machine OFF and then ON again.
IPSec Setting
1. Press [Next] of Network Security, and then
[Change] of IPSec.
2. Press [On].
3. Press [On] and [Off] of Rule Setting.
4. Press [OK].
5. After changing the setting, restart the system or
turn the machine OFF and then ON again.
Interface Block Setting
USB Host (USB memory slot setting)
1. Press [Next] of Interface Block Setting and then
[Change] of USB Host.
2. Press [Block].
3. Press [OK].
USB Device (USB interface setting)
1. Press [Next] of Interface Block Setting and then
[Change] of USB Device.
2. Press [Block].
3. Press [OK].
Optional interface (Optional interface card setting)
1. Press [Next] of Interface Block Setting and then
[Change] of Optional Interface 1 or Optional Inter-
face 2.
2. Press [Block].
3. Press [OK].
Security Level (Security Level setting)
Document Guard Setting
1. Press and then [Change] of Document Guard.
2. Press [On].
To scan documents, press [Off].
3. Press [OK].
Optional Functions
Starting Application Use
1. Press [Next] of Optional Function.
2. Select the desired application and press [License
On].
You can view detailed information on the selected
application by pressing [Detail].
3. In the license key entry screen, press [Official].
Some applications do not require you to enter an
license key. If the license key entry screen does not
appear, go to Step 4.
To use the application as a trial, press [Trial] without
entering the license key.
4. When the confirmation screen appears, press
[Yes].
To Next Page
Loading...
