Kyocera TASKalfa 400ci - Offset Occurs; The Leading Edge of the Image Is Sporadically Misaligned with the Original; Paper Creases

2JZ/2JX/2JV/2H7
1-4-65
(12) The leading edge of the image is sporadically misaligned with the original.
(13) Paper creases.
(14) Offset occurs.
Copy example Causes Check procedures/corrective measures
Paper feed clutch 1/2, paper convey-
ing clutch, MP paper feed clutch, MP
paper conveying clutch or registration
clutch installed or operating incor-
rectly.
Check the installation position and operation of paper feed
clutch 1/2, paper conveying clutch, MP paper feed clutch, MP
paper conveying clutch and registration clutch. If any of them
operates incorrectly, replace it.
Copy example Causes Check procedures/corrective measures
Paper curled. Check the paper storage conditions.
Paper damp. Check the paper storage conditions.
Dirty separation electrode. Clean the separation electrode.
Copy example Causes Check procedures/corrective measures
Defective cleaning blade of the drum
unit.
Replace the drum unit (see page 1-5-35).
Faulty transfer belt cleaning. Run maintenance item U107 (see page 1-3-58).
Replace the transfer belt unit (see page 1-5-37).
Defective fuser unit. Replace the fuser unit (see page 1-5-41).
Wrong types of paper. Check if the paper meets specifications. Replace paper.