2JZ/2JX/2JV/2H7-1
1-3-2
(2) Maintenance mode item list
Section
Item
No.
Content of maintenance item
Initial setting*
25/25,30/30 ppm 40/40 ppm 50/40 ppm
General U000 Outputting an own-status report -
U001 Exiting the maintenance mode -
U002 Setting the factory default data -
U003 Setting the service telephone number -
U004 Setting the machine number -
U019 Displaying the ROM version -
Initialization U021 Memory initializing -
U024 HDD formatting -
Drive, paper
feed and
paper con-
veying sys-
tem
U030 Checking the operation of the motors -
U031 Checking switches and sensors for paper conveying -
U032 Checking the operation of the clutches -
U033 Checking the operation of the solenoids -
U034 Adjusting the print start timing
LSUOUT TOP
LSUOUT LEFT
LSUOUT TOP B/W
0/0/0/0/0/0/0/0/0/0/0/0
0/0/0/0/0/0
0/0/0/0/0/0
U035 Setting the printing area for folio paper
Length/Width 330/210
U037 Checking the operation of the fan motors -
U051 Adjusting the deflection in the paper
Paper Loop Amount 0/1/0/1/0/6/0/
-9/0/-9/0/-4
0/7/0/7/-2/7/0/
-2/0/-2/0/-2
Paper Loop Amount B/W 0/0/0/0
U052 Setting the fuser motor control
Set Loop Sensor
Loop Sensor Control
Loop Sensor Valid
-
OFF/ON/ON/ON
OFF
U053 Setting the adjustment of the motor speed
Set MOTOR 1 0/0/0/0/0/0/0/0 4/4/4/4/0/0/0/0
Set MOTOR 2 -351/-351/0/0/0/0/0
Set MOTOR 3 0/0/0/0/0/-50 0/0/0/150/0/-50
Set MOTOR 4 27 20 17
Set MOTOR 5 -178/0/50/50/0
Set MOTOR 6 0/0/0/380/0
U059 Setting fan mode MODE1/0
Optical U061 Checking the operation of the exposure lamp -
U063 Adjusting the shading position 0
U065 Adjusting the scanner magnification 0/0
U066 Adjusting the scanner leading edge registration 0/0
U067 Adjusting the scanner center line 0/0
U068 Adjusting the scanning position for originals from the
DP
0/0
U070 Adjusting the DP magnification 0/0/0/0
*Initial setting for executing U020, *1: The item initialized for executing U021
To Next Page
Loading...
