Kyocera TASKalfa 400ci - Removing the Eject Spacer and Silica Gel; Removing the Tapes; Installing the Paper Feeder (Option)

2JZ/2JX/2JV/2H7
1-2-6
1. Remove the eject spacer and silica gel from
the eject section.
Figure 1-2-6
1. Remove three tapes.
Figure 1-2-7
1. Install the optional paper feeder as necessary.
2. Verify levelness at the four corners of the contact glass using a level gauge, and adjust the
level bolts at the bottom of the machine to optimize levelness.
Removing the eject spacer and silica gel.
Eject spacer
Silica gel
Removing the tapes.
Tap e
Tap e
Tap e
Installing the paper feeder (option).