Kyocera TASKalfa 400ci - Codes F000 - F090; Codes C9060 - C9550

2JZ/2JX/2JV/2H7
1-4-59
C9060 DP EEPROM error (optional DP)
Read and write data does not match.
Data in the specified area of the backup
memory does not match the specified
values.
Defective DP main
PWB.
Replace the DP main PWB and check for
correct operation.
Device damage of
EEPROM.
Contact the Service Administrative Division.
C9070 Communication problem between DP
and SHD (optional DP)
A communication error is detected.
Loose connection
of the SHD PWB.
Reinsert the connector. Also check for conti-
nuity within the connector cable. If none,
remedy or replace the cable.
Defective SHD
PWB.
Replace the SHD PWB and check for cor-
rect operation.
C9080 Communication problem between DP
and CIS (optional DP)
A communication error is detected.
Loose connection
of CIS.
Reinsert the connector. Also check for conti-
nuity within the connector cable. If none,
remedy or replace the cable.
Defective CIS. Replace CIS and check for correct opera-
tion.
C9500 Contact the Service Administrative Division.
C9510 Contact the Service Administrative Division.
C9520 Contact the Service Administrative Division.
C9530 Contact the Service Administrative Division.
C9540 Contact the Service Administrative Division.
C9550 Contact the Service Administrative Division.
F000 Operation panel PWB communication
error
Defective main
PWB.
Replace the main PWB and check for cor-
rect operation.
Defective main
operation panel
PWB.
Replace the main operation panel PWB and
check for correct operation.
F040 Engine PWB communication error Defective main
PWB.
Replace the main PWB and check for cor-
rect operation.
Defective engine
PWB.
Replace the engine PWB and check for cor-
rect operation.
F041 Scanner PWB communication error Defective main
PWB.
Replace the main PWB and check for cor-
rect operation.
Defective ISM
PWB.
Replace the ISM PWB and check for correct
operation.
F050
Engine ROM checksum error Defective engine
PWB.
Replace the engine PWB and check for cor-
rect operation.
F090 Fax control PWB communication
error
Defective main
PWB.
Replace the main PWB and check for cor-
rect operation.
Code Contents
Remarks
Causes Check procedures/corrective measures