Kyocera TASKalfa 400ci - Detaching and Refitting the Charger Roller Unit

2JZ/2JX/2JV/2H7
1-5-36
(4) Detaching and refitting the charger roller unit
Follow the procedure below to replace the charger roller unit.
Example of detaching and refitting: charger roller unit Y
Procedure
1. Remove the image formation holder (see
page 1-5-30).
2. Remove the screw and then remove the
charger roller unit Y.
3. Check or replace the charger roller unit Y
and refit all the removed parts.
4. When the charger roller unit is replaced with
a new one, carry out the following proce-
dure.
5. Perform maintenance mode U930 (clearing
the charger roller count) (see page 1-3-138).
Figure 1-5-62
Charger roller unit Y
Screw