Kyocera TASKalfa 400ci - Detaching and Refitting the Hard Disk Unit

2JZ/2JX/2JV/2H7
1-5-44
(2) Detaching and refitting the hard disk unit
Follow the procedure below to replace the hard disk unit.
Procedure
1. Perform maintenance mode U917 (backup
data reading) (see page 1-3-135).
2. Remove the upper rear cover (see page 1-
5-21).
3. Remove two cable clamps.
4. Pressing the lock lever and remove the fol-
lowing connectors
40/40, 50/40 ppm model:
connector (blue), connector (black)
25/25 30/30 ppm model:
connector (black)
Figure 1-5-74
5. Remove the connector.
6. Release the wire saddle and then remove
the wire.
7. Remove two screws.
Figure 1-5-75
Connector
Lock lever
Connector (black)
Cable clamps
Cable clamp
Connector (blue)
(40/40,50/40 ppm
model only)
Connector
Screw
Wire
Wire saddle
Screw