2JZ/2JX/2JV/2H7-1
1-3-73
U147
Setting for toner applying operation
Description
Sets the mode for removing charged toner in the developing unit (T7 control: Toner applying operation).
Purpose
Changing settings are not required. However, when the documents with lower print density (e.g. less than 2%)
should customarily printed in a great volume, mode must be changed.
If the charged toner stays inside the developing unit, density decreases.
Method
1. Press the start key.
2. Select the item to be set. The setting screen for the selected item is displayed.
Setting: [Transition Time]
1. Change the setting value using the +/- or numeric keys.
2. Press the start key. The value is set.
Setting: [Set Operation Mode]
1. Select the item to be set.
Initial setting; MODE1
2. Press the start key. The setting is set.
Maintenance
item No.
Description
Display Description
Transition Time Duration of toner applying
Set Operation Mode Settings for toner applying operation
Upper Limit Upper limit printing ratio of toner applying quantity with each mode
Sleeve Cleaning Toner collection operational interval on developing sleeve after the
toner applying operation (T7 control)
Set Drum Cleaning Mode Settings for developing the toner layer in accordance with coverage
ratio
Set Minimum Value Toner layer width when [Set Drum Cleaning Mode] is selected
Display Description Setting range Initial setting
Transition Time Duration of toner applying 0 to 255 (s) 70
Display Description
OFF Do not applying the toner operation
MODE1 Normal mode
MODE2 Toner consumption mode
MODE3 Normal mode (setting value is changed possibility)
To Next Page
Loading...
