2JZ/2JX/2JV/2H7-1
1-3-79
U161
Setting the fuser control temperature
Description
Changes the fuser control temperature.
Purpose
Normally no change is necessary. However, can be used to prevent curling or creasing of paper, or solve a
fuser problem on thick paper.
Setting
1. Press the start key.
2. Select the item to be set.
3. Change the setting using the +/- or numeric keys.
*1: 40/40, 50/40 ppm model *2: 25/25, 30/30 ppm model
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
U163
Resetting the fuser problem data
Description
Resets the detection of a service call code indicating a problem in the fuser section.
Purpose
To prevent accidents due to an abnormally high fuser temperature.
Method
1. Press the start key.
2. Press [Execute].
3. Press the start key. The fuser problem data is initialized.
4. Turn the main power switch off and on.
U167
Checking/clearing the fuser count
Description
Displays and clears the fuser count for checking.
Purpose
To check or clear the fuser count after replacement of the fuser unit. Also to clear the counts after replacing
unit.
Method
1. Press the start key. The fuser count is displayed.
Clearing
1. Press [Clear Counter].
2. Press the start key. The count is cleared.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
Maintenance
item No.
Description
Display Description Setting range Initial setting
Ready Temp. Standby temperature control 50 to 200 160
*1
/153
*2
Stable (Driving) Stabilized temperature during operation 130 to 200 165
*1
/160
*2
Stable (Stop) Stabilized temperature under suspension 130 to 200 165
*1
/160
*2
Temp. Print Full Temperature control during printing 130 to 200 165
*1
/160
*2
Shift Print Dup Temperature control during duplex-printing -10 to 0 -5
*1
/0
*2
P. Roller Temp. Press roller control temperature 100 to 160 140
*1
/130
*2
Display Description
Fixing Counter Fuser count value
To Next Page
Loading...
