Kyocera TASKalfa 400ci - Codes C8030 - C8060

2JZ/2JX/2JV/2H7-1
1-4-51
C8030 Tray upper limit detection problem
(optional document finisher)
When the tray elevation motor raises a
tray, the ON status of the tray upper limit
sensor is detected.
The tray upper limit
sensor, paper sur-
face sensor 1/2
connector makes
poor contact.
Reinsert the connector. Also check for conti-
nuity within the connector cable. If none,
remedy or replace the cable.
Defective tray
upper limit sensor,
paper surface sen-
sor 1/2.
Replace the sensor.
Defective finisher
main PWB.
Replace the finisher main PWB and check
for correct operation.
C8040 Belt problem (optional document fin-
isher)
The belt sensor does not turn on/off
within specified time of the belt solenoid
turning on.
The belt sensor,
belt solenoid con-
nector makes poor
contact.
Reinsert the connector. Also check for conti-
nuity within the connector cable. If none,
remedy or replace the cable.
Defective belt sen-
sor.
Replace the belt sensor.
Defective belt sole-
noid.
Replace the belt solenoid.
Defective finisher
main PWB.
Replace the finisher main PWB and check
for correct operation.
C8050 Paper conveying belt motor 1 prob-
lem (optional 3000-sheet document
finisher)
Paper conveying belt home position sen-
sor 1 does not turn off within 1.5 s.
Paper conveying belt home position sen-
sor 1 does not turn on within 2.5 s.
Jam 88 is indicated.
Poor contact in the
connector termi-
nals.
Check the connection of connector YC2 on
the inner tray PWB and the connector on
paper conveying belt motor 1, and the conti-
nuity across the connector terminals. Repair
or replace if necessary.
Defective paper
conveying belt
home position sen-
sor 1.
Replace paper conveying belt home position
sensor 1.
Defective paper
conveying belt
motor 1.
Replace paper conveying belt motor 1.
Defective PWB. Replace the inner tray PWB or finisher main
PWB and check for correct operation.
C8060 Paper conveying belt motor 2 prob-
lem (optional 3000-sheet document
finisher)
Paper conveying belt home position sen-
sor 2 does not turn off within 1.5 s.
Paper conveying belt home position sen-
sor 2 does not turn on within 1.5 s.
Poor contact in the
connector termi-
nals.
Check the connection of connector YC6 on
the inner tray PWB and the connector on
paper conveying belt motor 2, and the conti-
nuity across the connector terminals. Repair
or replace if necessary.
Defective paper
conveying belt
home position sen-
sor 2.
Replace paper conveying belt home position
sensor 2.
Defective paper
conveying belt
motor 2.
Replace paper conveying belt motor 2.
Defective PWB. Replace the inner tray PWB or finisher main
PWB and check for correct operation.
Code Contents
Remarks
Causes Check procedures/corrective measures