Kyocera TASKalfa 400ci - Fuser Section Overview

2JZ/2JX/2JV/2H7
2-1-18
2-1-6 Fuser section
(1) Fuser section
The fuser section consists of the parts shown in figure below. When paper reaches the fuser section after the secondary
transfer process, it passes between the press roller and melt belt. Pressure is applied by the fuser unit pressure springs so
that the toner on the paper is melted, fused and fixed onto the paper. The melt belt is heated by fuser heaters 1 (FH1) or 2
(FH2) inside the heat roller. The press roller is heated by fuser heater 3 (FH3) (40/40, 50/40 ppm model only).
Figure 2-1-20 Fuser section
19
12
20
10
4
14
7
215 6 5
9
1
13
3
8
111716 18
(1) Heat roller
(2) Fuser roller
(3) Melt belt
(4) Press roller
(5) Fuser heater 1 (FH1)
(6) Fuser heater 2 (FH2)
(7) Fuser heater 3 (FH3)*
(8) Fuser thermistor 1 (FTH1)
(9) Fuser thermistor 2 (FTH2)
(10) Fuser thermistor 3 (FTH3)*
(11) Fuser thermostat 1 (FTS1)
(12) Fuser thermostat 2 (FTS2)*
(13) Right fuser cover
(14) Left fuser cover
(15) Fuser entry guide
(16) Fuser charge erasing brush
(17) Fuser eject pulley
(18) Right eject guide
(19) Feedshift roller
(20) Left eject guide
*: 40/40, 50/40 ppm model only.