2JZ/2JX/2JV/2H7
1-2-11
1. Remove two screws and then remove the
lid.
2. Pull the connector of the cassette heater
wire out from the aperture.
3. Connect the jumper connector to the con-
nector of the cassette heater wire.
4. Seat the cassette heater wire into the
machine inside.
5. Refit the lid.
Figure 1-2-15
1. Connect the power cord to the power cord connector on lower left of the machine.
2. Connect the power plug to the wall outlet.
Connecting the cassette heater.
Lid
Screws
Connector
Cassette
heater wire
Cassette
heater wire
Jumper connector
Connector
Aperture
Connecting the power cord.
To Next Page
Loading...
