2JZ/2JX/2JV/2H7-1
1-3-128
U473
Setting: [Density Correction]
1. Select ON or OFF.
Initial setting: ON
2. Press the start key. The setting is set.
Setting: [Input Density Adjust Value]
1. Select the color.
2. Enter the setting value on the sheet suppled with LSU using the +/- or numeric keys.
3. Press the start key. The value is set.
Setting: [Set Density(EmitTime/Dot)]
1. Select [BLACK] or [ALL].
2. Select the item..
Initial setting: ALL: 0
3. Press the start key. The setting is set.
Supplement
When selecting [Adjust Laser Power Output] or [Input Density Adjust Value], copying from an original is avail-
able in the interrupt copying mode.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
Maintenance
item No.
Description
Display Description
ON Correct the sensitivity
OFF Do not correct the sensitivity
Display Description
CYAN Exposure density correction value for cyan
MAGENTA Exposure density correction value for magenta
YELLOW Exposure density correction value for yellow
BLACK Exposure density correction value for black
Display Description Setting range
X0 (C) - X10 (C) Enter the setting value for cyan -30 to 30
X0 (M) - X10 (M) Enter the setting value for magenta -30 to 30
X0 (Y) - X10 (Y) Enter the setting value for yellow -30 to 30
X0 (K) - X10 (K) Enter the setting value for black -30 to 30
Display Description
BLACK LSU laser output for black
ALL LSU laser output for all colors
Display Description
0 (100%) LSU laser output (100%)
1 (90%) LSU laser output (90%)
2 (80%) LSU laser output (80%)
3 (70%) LSU laser output (70%)
To Next Page
Loading...
