Kyocera TASKalfa 400ci - Page 70

2JZ/2JX/2JV/2H7-1
1-3-26
U034 When [LSUOUT TOP B/W] is selected.
Large size: 218 mm or more in width of paper.
3. Press the system menu key.
4. Press the start key to output a test pattern.
5. Press the system menu key.
6. Change the setting value using the +/- or numeric keys.
For output example 1, increase the value. For output example 2, decrease the value.
Figure 1-3-4
7. Press the start key. The value is set.
Remark
When changing the setting value of [Large] each item is modified, equal to amount of the value which is
changed adds also the value of [Small] each item and is pulled.
Caution
Check the copy image after the adjustment. If the image is still incorrect, perform the following adjustments in
maintenance mode.
Maintenance
item No.
Description
Display Description Setting
range
Default
setting
Change in
value per step
LSUOUT TOP
MPT (L) B/W
Paper feed from MP tray
(when large size paper is used)
-3.0 to 3.0 0 0.1 mm
LSUOUT TOP
CAS (L) B/W
Paper feed from cassette
(when large size paper is used)
-3.0 to 3.0 0 0.1 mm
LSUOUT TOP
DUP (L) B/W
Duplex mode (second)
(when large size paper is used)
-3.0 to 3.0 0 0.1 mm
LSUOUT TOP
MPT (S) B/W
Paper feed from MP tray
(when small size paper is used)
-3.0 to 3.0 0 0.1 mm
LSUOUT TOP
CAS (S) B/W
Paper feed from cassette
(when small size paper is used)
-3.0 to 3.0 0 0.1 mm
LSUOUT TOP
DUP (S) B/W
Duplex mode (second)
(when small size paper is used)
-3.0 to 3.0 0 0.1 mm
Correct image
Output
example 1
Output
example 2
Leading edge
registration
(20 ± 1.5 mm)
U034
U066
(P.1-3-37)
U071
(P.1-3-41)