Action Yes No
Step 10
Replace the ADF controller card assembly. Go to
“ADF controller
card removal” on page 541.
Does the problem remain?
Go to step 11. The problem is
solved.
Step 11
Perform a print test using the ADF.
Does the problem remain?
Contact the next
level of support.
The problem is
solved.
Sensor (ADF 2nd scan) late jam service check
Action Yes No
Step 1
a Check the sensor (ADF 2nd scan) for proper installation.
b If necessary, remove and then reinstall the sensor.
Does the problem remain?
Go to step 2. The problem is
solved.
Step 2
Check the sensor (ADF 2nd scan) for proper operation.
a Enter the Diagnostics menu.
b Select Scanner tests > Sensor tests.
c Observe the line, “sensor (ADF 2nd scan).”
Does the display on the operator panel change every time the
sensing area of the sensor is interrupted or blocked?
The problem is
solved.
Go to step 3.
Step 3
a Check the sensor (ADF 2nd scan) for proper connection.
b Replace the connection, if necessary.
Does the problem remain?
Go to step 4. The problem is
solved.
Step 4
Replace the sensor (ADF 2nd scan). Go to
“Sensor (ADF 2nd scan)
removal” on page 555.
Does the problem remain?
Contact the next
level of support.
The problem is
solved.
7462
Diagnostic information
177
To Next Page
Loading...
