Lexmark 7462 series - Key Repeat Initial Delay

Key Repeat Initial Delay
This setting determines the length of delay before a repeating key starts repeating. The range is 0.25–5
seconds, with increments of 0.25. One second is the factory default setting.
1 From the Configuration menu, navigate to Key Repeat Initial Delay.
2 Adjust the setting.
3 Tou ch Submit to apply the changes.
Key Repeat Rate
This setting indicates the number of presses per second for repeating keys. The range is 1–100. 15 presses per
second is the factory default setting.
1 From the Configuration menu, navigate to Key Repeat Rate.
2 Adjust the setting.
3 Tou ch Submit to apply the changes.
Wiper Messages
1 From the Configuration menu, select Wiper Messages.
2 Select On or O.
Note: On is the factory default setting.
3 Depending on your printer model, touch Submit or press the Select button to apply the changes.
Clear Custom Status
Executing this operation erases any strings that have been defined by the user for the default or alternate
custom messages.
1 From the
Configuration
menu, select Clear Custom Status.
2 Press the Select button to start the operation.
7462
Service menus
287