HARDWARE TESTS
Panel Test
This test automatically toggles each pixel of the display or home screen, depending on your printer model,
through every contrast level beginning with the darkest to the brightest. This continues until you press the Stop
button.
Button Test
This test
verifies
the operation of the buttons on the operator panel. When Button Test is selected, a diagram
of the operator panel appears on the panel.
If you press a button on the operator panel while running the test, then the corresponding touch screen key is
emphasized. Touch Back to cancel the test.
DRAM Test
This test checks the validity of the standard and optional dynamic random access memory (DRAM). The test
repeatedly writes patterns of data to the DRAM to verify that each bit in the memory can be set and read
correctly.
1 From the Diagnostics menu, navigate to HARDWARE TESTS > DRAM Test.
Note: The printer performs the test and then resets.
2 After the printer resets, the results of the test appear: DRAM Test [x] P:###### F:######.
Where:
• [x] represents the size of the installed DRAM.
• P:###### represents the number of times the memory test passed and finished successfully.
The maximum pass count is 999,999.
• F:##### represents the number of times the memory test failed and finished with errors.
The maximum pass count is 999,999.
Note: After the maximum pass or fail count is reached or when all the DRAM has been tested, the test
stops and the final results appear.
3 To stop the test before completion, turn o the printer.
CACHE Test
This test verifies the printer processor cache.
1 From the Diagnostics menu, navigate to HARDWARE TESTS > CACHE Test.
Note: The printer performs the test and then resets.
2 After the printer resets, the results of the test appear: Cache Test <### P:###### F:######.
7462
Service menus
266
To Next Page
Loading...
