Sensor (HCIT pass through) with cable removal
Note: Carefully remove the base machine from the HCIT tray assembly before proceeding.
1 Remove the HCIT cover, left. Go to “High capacity input tray (HCIT) cover, left removal” on page 423.
2 Disconnect the sensor (HCIT pass through) cable connector from the HCIT controller card assembly.
Note: Remove the cable restraint, and observe the routing for reinstallation.
3 Release the hooks (A) securing the sensor (HCIT pass through) to the machine.
4 Remove the sensor (HCIT pass through) with cable from the top plate.
A
A
7462
Repair information
470
To Next Page
Loading...
