Action Yes No
Step 4
Check the transfer roll assembly for contamination and wear, and
replace the transfer roll assembly if necessary. Go to
“Transfer roll
assembly removal” on page 351.
Does the problem remain?
Go to step 5. Problem is solved.
Step 5
Check the alignment assembly for proper adjustment. Go to
“Alignment assembly adjustment” on page 305. If necessary,
replace the aligner assembly. Go to
“Alignment assembly
removal” on page 309.
Does the problem remain?
Go to step 6. Problem is solved.
Step 6
Remove the fuser unit assembly, and then check the heat roll and
pressure roll for contamination or cracks. If necessary, replace the
fuser unit assembly. Go to
“Fuser unit assembly removal” on
page 373.
CAUTION—HOT SURFACE: Allow the fuser unit assembly
to cool down.
Does the problem remain?
Contact the next
level of support.
Problem is solved.
No fuse check
Leading edge
Trailing edge
ABC
DEF
Action Yes No
Step 1
Adjust the printer media settings to match the media type loaded.
Does the problem remain?
Go to step 2. The problem is
solved.
Step 2
Check the fuser unit assembly for proper installation. If necessary,
remove and then reinstall the assembly.
Does the problem remain?
Go to step 3. The problem is
solved.
7462
Diagnostic information
58
To Next Page
Loading...
