Sensor (platen glass length) assembly removal
1 Remove the scanner platen glass cover assembly. Go to “Scanner platen glass cover assembly removal
(models X651, X652, X654, and X656)” on page 527 or “Scanner platen glass cover assembly removal
(model X658)” on page 527.
2 Remove the two screws (A) securing the sensor (platen glass length) assembly to the scanner flatbed frame.
3 Remove the screw (B) securing the sensor (platen glass length) cable cover.
AB
4 Rotate the sensor (platen glass length) assembly upside down, and remove the harness from each individual
sensor.
5 Remove the sensor (platen glass length) assembly.
7462
Repair information
516
To Next Page
Loading...
