#Part
4 Sensor (duplex input)
5 Pick arm assembly
6 Sensor (option pass through)
7PC cartridge
8Sensor (input)
9PC drum
Functions of main components
When the 250 or 550 sheet input trays are installed under the printer, additional trays are available.
Media tray assembly
It is necessary to adjust the media tray rear guide and media tray side guide of the media tray assembly to
match the media size.
Rear media guide
The rear media tray guide assembly can be adjusted to
dierent
media sizes by moving it to the front or rear.
The rear guide should come into contact with the media and hold it in position.
Side guide
The media tray assembly is designed so it can adapt to the media width in the media feed direction by moving
the side guide to the left or right.
Wear strips
The wear strips are designed to provide a fixed resistance to ensure that a single piece of paper is properly
fed out of the media tray. There are several types of wear strips available for custom or hard to feed media.
Media tray assembly
Rear media guide
Bottom plate
End guide
7462
Appendix C: Theory of operation
680
To Next Page
Loading...
