4-bin mailbox assembly deflector gate solenoid removal
1 Remove the 4‑bin mailbox assembly top cover. Go to “4-bin mailbox assembly top cover removal” on
page 391.
2 Remove the screw (A) securing the deflector gate solenoid to the 4-bin mailbox assembly.
A
3 Carefully unroute the deflector gate solenoid cables from the cable clips under the top cover.
4 Disconnect the appropriate deflector gate solenoid cable from the controller card.
5 Pull the deflector gate solenoid and the harness from the 4‑bin mailbox assembly.
4-bin mailbox assembly transport solenoid removal
1 Remove the 4‑bin mailbox assembly left cover. Go to “4-bin mailbox assembly left cover removal” on
page 386.
2 Remove the left rear inner cover.
3 Disconnect the transport solenoid cable from the controller card.
7462
Repair information
393
To Next Page
Loading...
