Lexmark 7462 series - Reports

• Cleans the transfer roll
• Calculates reflectivity ratios and operating points to attain the darkness target of each operating point
• Modifies the EP mechanism as necessary to adjust toner darkness
The cartridge smart chip controls how often this process executes.
1 From the Diagnostics menu, navigate to EP SETUP > Auto Dark Adj.
2 Select Enable or Disable.
3 Apply the changes.
REPORTS
Menu Settings Page
This setting prints the menu settings page. From the Diagnostics menu, navigate to REPORTS > Menu Settings
Page. The following settings are printed:
• Maintenance Counter Value
• USB Scan to Local
• Print Quality Pages
• Reports
• Size Sensing
• Panel Menu
• PPDS Emulation
• Factory Defaults
• Energy Conserve
• Min Copy Memory
• NumPad Job Assist
• Fax Storage Location
• ADF Edge Erase
• FB Edge Erase
• Scanner Manual Registration
• Disable Scanner
• Paper Prompts
• Envelope Prompts
• Disk Encryption
• Wipe Disk
• Font Sharpening
• Required Standby
• LES Applications
• Key Repeat Initial Delay
• Key Repeat Rate
• Wiper Message
• Clear Custom Status
7462
Service menus
276