Lexmark 7462 series - Receive Complete

Receive complete
The printer has received an entire fax job. Wait for the message to clear.
Receiving page <n>
The printer receives page <n> of the fax job, where <n> is the number of the page received. Wait for the
message to clear.
Remove packaging material, check <x>
Remove any remaining packaging material from the specified location.
Remove paper from <linked bin set name>
Remove the paper from the specified bin. The printer automatically senses paper removal and resumes
printing.
If removing the paper does not clear the message, then touch Continue.
Remove paper from all bins
Remove the paper from all of the bins. The printer automatically senses paper removal and resumes printing.
If removing the paper does not clear the message, then touch Continue.
Remove paper from bin <x>
Remove the paper from the specified bin. The printer automatically senses paper removal and resumes
printing.
If removing the paper does not clear the message, then touch Continue.
Remove paper from standard output bin
Remove the stack of paper from the standard exit bin.
Replace <x> if restarting job.
One or more messages which interrupted a scan job are now cleared. Replace the original documents in
the scanner to restart the scan job. <x> is a page of the scan job.
Try one or more of the following:
• Tou ch Cancel Job if a scan job is processing when the message appears. This cancels the job and
clears the message.
• Tou ch Scan from Automatic Document Feeder if the page jam recovery is active. Scanning resumes
from the ADF immediately after the last successfully scanned page.
• Tou ch Scan from
flatbed
if page jam recovery is active. Scanning resumes from the scanner glass
immediately after the last successfully scanned page.
7462
Diagnostic information
191