Lexmark 7462 series - Sensor (ADF Media Exit) Bracket Assembly Removal (Model X651)

6 Remove the screw (B) from the ground strap.
A
B
7 Remove the sensor (ADF media exit) fan bracket assembly.
Sensor (ADF media exit) bracket assembly removal (model X651)
1 Remove the ADF front cover. Go to “ADF front cover removal” on page 537.
2 Remove the ADF rear cover. Go to “ADF rear cover removal” on page 538.
3 Open the ADF top door assembly.
4 Disconnect the ground strap, the fan (CN12) harness, and the media exit sensor (CN9) harness.
5 Remove the two screws (A) on the front and rear of the sensor (ADF media exit) fan bracket assembly.
7462
Repair information
549