May 19, 2016
• Updated the 250‑ and 550‑sheet tray assemblies (Assemblies 15 and 17) to remove the following parts that
are not anymore FRUs:
– Tray front cover
– Tray right cover
– Tray left cover
January 8, 2016
• Changed the part number of the input sensor from 40X4368 to 40X8673.
October 20, 2015
• Created this new intervention‑required message, “81 Routine Maintenance” on page 200.
• Updated “User attendance messages (0‑99)” on page 202 to include an entry for 81 Routine
Maintenance.
• Created “Replace fuser service check” on page 214.
• Updated “Individual maintenance part expected life” on page 567 to change the part number for the
charge roll assembly with tool from 40X5852 to 40X0127.
August 21, 2015
• Updated all fuser‑related service check topics for 201 and 202 error messages in the Diagnostic information
chapter.
January 27, 2015
• Updated the Solid black service check in the Diagnostic information chapter.
January 9, 2015
• Remove the 202.30 error code entry from the Error code table in the Diagnostic information chapter.
December 5, 2014
• Parts catalog Assembly 17—Replaced part number 40X4469 with 40X5786.
October 30, 2014
• Updated the graphic in the Assembly 5 parts catalog in the Pars catalog chapter.
• Replaced part number 40X4417 with 41X4417 in the Assembly 1 parts catalog in the Parts catalog chapter.
September 29, 2014
• Updated Assembly 5 parts catalog art in the Parts catalog chapter.
June 2, 2014
• Added staple cartridge holder (40X7466) to parts catalog Assembly 20.
May 2, 2014
• Changed all references to J15‑3 to J20‑4 in the possible repair action for “917.00” error code in the 9yy error
code table.
7462
Preface
28
To Next Page
Loading...
