4-bin mailbox removals
4-bin mailbox assembly left cover removal
1 Place the 4‑bin mailbox assembly on its side.
2 Remove the two screws (A) on the underside of the 4-bin mailbox assembly securing the left cover.
A
3 Using your finger, pull up on the top surface of the left cover while simultaneously pulling out, and remove.
4-bin mailbox assembly controller card assembly removal
1 Remove the 4‑bin mailbox assembly left cover. Go to “4-bin mailbox assembly left cover removal” on
page 386.
2 Disconnect all harnesses from the controller card.
Note: Label each deflector gate solenoid cable for correct replacement upon installation.
7462
Repair information
386
To Next Page
Loading...
