Sensor (HCIT tray raised HP) with cable assembly removal
Note: Carefully remove the base machine from the HCIT tray assembly before proceeding.
1 Remove the HCIT cover, left. Go to “High capacity input tray (HCIT) cover, left removal” on page 423.
2 Disconnect the sensor (HCIT tray raised HP) cable connector from the HCIT controller card assembly.
Note: Remove the cable from the restraints, and observe the routing for reinstallation.
3 Remove the screw (A) securing the sensor to the rear frame.
7462
Repair information
468
To Next Page
Loading...
