High capacity stacker switch (media bin HP) removal
1 Remove the high capacity stacker controller card cover panel. Go to “High capacity stacker controller card
cover panel removal” on page 437.
2 Remove the two screws (A) securing the high capacity stacker switch (media bin HP) to the left frame.
A
3 Disconnect the high capacity stacker switch (media bin HP) harness from the upper controller card.
4 Remove the high capacity stacker switch (media bin HP).
High capacity stacker sensor (media bin full) assembly removal
1 Remove the high capacity stacker controller card cover panel. Go to “High capacity stacker controller card
cover panel removal” on page 437.
2 Release the tabs securing the high capacity stacker sensor (media bin full) assembly to the left frame.
3 Disconnect the sensor (media bin full) harness from the upper controller card.
7462
Repair information
438
To Next Page
Loading...
