Lexmark 7462 series - Supported Paper Sizes, Types, and Weights

Recycled paper, paper of lower weight (<60 g/m
2
[16 lb bond]) and/or lower caliper (<3.8 mils [0.1 mm]), and
paper that is cut grain-short for portrait (or short-edge) fed printers may have lower bending resistance than is
required for reliable paper feeding. Before using these types of paper for laser (electrophotographic) printing,
consult your paper supplier. Remember that these are general guidelines only and that paper meeting these
guidelines may still cause paper feeding problems in any laser printer (for example, if the paper curls excessively
under normal printing conditions).
Supported paper sizes, types, and weights
The following tables provide information on standard and optional paper sources and the types of paper they
support.
Note: For an unlisted paper size, configure a Universal Paper Size.
For information on card stock and labels, see the Card Stock & Label Guide on the Lexmark Web site at
http://support.lexmark.com.
Paper sizes supported by the printer
Paper size Dimensions 250‑ or
550‑sheet
trays (standard
or optional)
Optional
2000‑sheet
tray
Multipurpose
feeder
Duplex unit
A4 210 x 297 mm
(8.3 x 11.7 in.)
A5 148 x 210 mm
(5.8 x 8.3 in.)
X
A6
1,2
105 x 148 mm
(4.1 x 5.8 in.)
XX X
JIS B5 182 x 257 mm
(7.2 x 10.1 in.)
X
Letter 216 x 279 mm
(8.5 x 11 in.)
Legal 216 x 356 mm
(8.5 x 14 in.)
Executive 184 x 267 mm
(7.3 x 10.5 in.)
X
Oficio
1
216 x 340 mm
(8.5 x 13.4 in.)
X
1
This size appears in the Paper Size menu only when the paper source does not support size sensing or when size
sensing is turned o.
2
Only the standard exit bin supports this size.
3
This size setting formats the page for 216 x 356 mm (8.5 x 14 in.) unless the size is
specified
by the software
application.
4
To support duplexing, the Universal width must be between 148 mm (5.8 in) and 216 mm (8.5 in); Universal length
must be between 182 mm (7.2 in) and 356 mm (14 in).
7462
General information
34