4 Remove the four screws (A) securing the ADF media pinch pad assembly.
A
5 Remove the ADF media pinch pad assembly.
Sensor (ADF media exit) fan bracket assembly removal (models X654,
X656, and X658)
1 Remove the ADF front cover. Go to “ADF front cover removal” on page 537.
2 Remove the ADF rear cover. Go to “ADF rear cover removal” on page 538.
3 Open the ADF top door assembly.
4 Disconnect the ground strap, the fan (CN12) harness, and the media exit sensor (CN9) harness.
5 Remove the two screws (A) on the front and rear of the sensor (ADF media exit) fan bracket assembly.
7462
Repair information
548
To Next Page
Loading...
