3 Configure any of the following margin settings.
• Top Margin (value: ‑25 to +25)—A positive change moves the image down the page and increases the
top margin. A negative change moves the image up and decreases the top margin.
• Bottom Margin (value: ‑20 to +20)—A positive change compresses the image so it appears to move
down the page and a negative change moves the image up.
• Left Margin (value: ‑25 to +25)—A positive change moves the image to the left and a negative change
moves the image to the right. No compression occurs.
• Right Margin (value: ‑10 to +10)—A positive change moves the image to the right and a negative change
moves the image to the left.
Notes:
• Use the left or right arrow button to decrease or increase the values.
• You need to print a test page every time you configure a margin setting in order to verify the
changes.
4 To uc h Submit to save the changes.
5 Touc h Back to exit REGISTRATION.
Printing a quick test page
Note: Use only A4‑ or letter‑size paper.
The test page contains the following information:
• Device information
• Printer margin settings
• Scanner margin settings
• Alignment diamonds at the top, bottom, and each side
• Horizontal lines for skew adjustment
• General printer information, including current page count, installed memory, processor speed, serial number,
engine ID, and system card ID
1 From the Diagnostics menu, select REGISTRATION.
2 Touch the right arrow button until Quick Test appears.
3 Press the Select button to start printing.
PRINT TESTS
This test determines if the printer can print on paper from any of the installed trays. Only the installed trays are
listed in the Print Tests menu.
The content of the test page varies depending on the paper in the selected tray. Check each test page from
each source to assist in print quality and paper feed problems.
7462
Service menus
264
To Next Page
Loading...
